Show me your cup holder

[Yetti]

[Derek]

Added these over the weekend.

[BobbyH]

12 hours ago, Derek said:

Added these over the weekend.

Those look pretty amazing, wonder if they would fit behind my J-bar?

[carusoam]

1 hour ago, BobbyH said:

Those look pretty amazing, wonder if they would fit behind my J-bar?

Very much depends on the year of the box in front of your J-bar…

Some got carpet, others got plastic…

Either way… slamming the Jbar between your favorite forgotten beverages could be surprising…

 

I usually get a reminder that the beverage cart will be coming through the cabin to pick up any unused beverages…. This will be the time to fold up the cup holders….   

PP attempted humor only…

Best regards,

-a-

[natdm]

On 3/31/2021 at 11:09 AM, ToddCC22 said:

I 3D printed mine. Came in just under 8 oz and holds my IPad when it doesn’t have drinks in it. Heat vent exits below it. 

Mooney Cup Holder with ipad 3.25 scalloped front angled v3.stl 299.79 kB · 25 downloads

What did you attach it with and what did you print it with?? I'd be shocked if the heat didn't melt PLA. Did you do ABS?

[Pinecone]

On 6/26/2022 at 12:21 PM, Derek said:

Added these over the weekend.

How did you attach them?  On the ones I got, the base is recessed, except the edge, so very littl contact with vlcro.

[M20F]

Standard cup holder in any Executive, alcohol not included. 

[blaine beaven]

7 hours ago, natdm said:

What did you attach it with and what did you print it with?? I'd be shocked if the heat didn't melt PLA. Did you do ABS?

I’ve got the same question!

[ToddCC22]

I printed it in PLA and attached it with 3M double sided adhesive tape. Sits above the heat duct and the heat flows under it. 

[natdm]

Thanks! I'm printing in PETG now just in case. I'll let you know how it goes.. in 20 hours.

[natdm]

I'll go attach it tonight probably. Well done @ToddCC22. 

 

[Fly Boomer]

6 hours ago, natdm said:

I'll go attach it tonight probably. Well done @ToddCC22. 

That looks great -- custom designed for your cup!

[Pinecone]

It needs a slot to hold a phone. 

I have a friend who is really into 3d printing making me one.

[natdm]

3 hours ago, Pinecone said:

It needs a slot to hold a phone. 

I have a friend who is really into 3d printing making me one.

Let's make this a thing! @ToddCC22 and your friend should put them on printables.

[Tim-37419]

On 8/15/2023 at 3:04 PM, ToddCC22 said:

I printed it in PLA and attached it with 3M double sided adhesive tape. Sits above the heat duct and the heat flows under it. 

@ToddCC22 - any idea if this would also fit in a J ?

[natdm]

32 minutes ago, Tim-37419 said:

@ToddCC22 - any idea if this would also fit in a J ?

Actually it doesn't fit in a K231... Found that out after printing it. 252 and 231 consoles are not the same, apparently. I wouldn't expect a 201 console to be like a 252 with that news.

Willing to bet the electric cowl flaps changed the console.