WTB: Front seat frame or back for '68 M20C

[DXB]

I;m gonna finally get the broken back support in the passenger seat from my '68 M20C fixed.  I'm told it's better to replace than weld. Anybody want to sell me a seat frame or just the back of one?

The official # from the parts catalog is 140153-503; I'm not sure which other ones might work, though the number is different for both '67 and '69.  @Alan Fox? @acpartswhse? 

[Alan Fox]

With or without a headrest ?

[DXB]

2 hours ago, Alan Fox said:

With or without a headrest ?

Need the channels for the headrest, but don't need headrest itself (can reuse the old one)

[RLCarter]

Wasn't there a thread a few years back on how to add/repair headrest mounts?

[MarkW]

I see that this as an old post, so I expect you may have solved your problem well before now. But just in case...

I have a pair of seats from a 62 M20C. The fabric is a little faded, etc., but still functional, seat belts attached and working, and both frames are fine. If you have an interest, let me know? No worries!

 

[carusoam]

Let’s see if Dev is around…. @DXB… (see note above, seats)

Best regards,

-a-

 

[MarkW]

8 hours ago, carusoam said:

Let’s see if Dev is around…. @DXB… (see note above, seats)

Best regards,

-a-

 

Thanks very much for the signal boost! The seats are still quite comfy. I had the whole interior redone recently, and got replacements in that process, so these are surplus to me. But there’s nothing wrong with them, and I’d like to see them go to a good home. I’ve got them on eBay right now, listed for $500 plus shipping for the pair. 
 

Thanks again! 
 

Best,

Mark

[DXB]

18 hours ago, carusoam said:

Let’s see if Dev is around…. @DXB… (see note above, seats)

Best regards,

-a-

 

Got the frame on mine welded a while back rather than replace - some advised against but holding up well so fat