If anyone needs landing gear aft fairings ...

[A64Pilot]

For those making them from carbon, be sure to put a layer of anti-chafe tape between them and the aluminum as carbon will cause corrosion if you don’t.

[Austintatious]

17 hours ago, M20Doc said:

I’ll look tomorrow 

Awesome, thank you!

[PT20J]

The Mooney parts are molded from a softer plastic and have some give where the gear doors overlap. If you make them out of stiffer composites, you might want to take a lot of care making sure the fit with the doors is very good so that they don’t wear out the doors. It doesn’t seem like Mooney got the curve exactly right and that’s probably why one corner always seems to wear. 

[Fly Boomer]

On 2/13/2017 at 10:38 AM, bradp said:

Last coat of tooling gelcoat went on when the temps rose enough to give me some hope that a 2% catalyst would get it to cure.  This is because there is so much toluene as the solvent that all must be done outdoors / garage with good ventilation and a respirator.  Nasty stuff. 

Next step is to sand and polish again, then it will be ready for part making. 

 

I have been watching this topic wondering if the part you are seeking could be 3D printed?  Seems like a ton of things are these days.

[Guest]

23 hours ago, Austintatious said:

Awesome, thank you!

I've got one Mooney right fairing p/n 550060-008

[Austintatious]

Its for an M20K ?

Do you know the PN for the left side?

How much do you want for it?

 

Edited April 25, 2023 by Austintatious

[Guest]

1 hour ago, Austintatious said:

Its for an M20K ?

Do you know the PN for the left side?

How much do you want for it?

 

From the IPC, -007 and -008.  Contact my wife tomorrow, maureen@tricityaero.com for pricing