Is this a Mooney yoke??

[mooneym20d]

Took this out of an early 201 - was this an original yoke?

[N9937c]

dont know but i have one too

larry

[Lood]

It looks like those that were installed in the early J models. I have a pair, now covered with leather, in my F. The main difference between these early models and the those used later, is that the early J's had the same diameter control shaft as the vintage models. However, the hole where they bolt onto the control shaft differ by 90 deg between the vintage models and the J's. IIRC, the thick control shaft was introduced around '79 - '80.

[N9937c]

Maybe some difference in the hole but the ones in all the Mooney's i've seen don't have the angled bottom. The grips are on protusions at 90 degrees.

larry

[ToddDPT]

My '77 J's yokes don't have that sharp angle at the bottom. 

[N601RX]

This is what is on my F.  I'm not sure what model J they came from.  They have the heavier shaft.  They don't have the sharp angle like yours does.  It looks like the ones you have would lower your hands a couple of inches.

[mooneym20d]

Thanks for all the replies. Still not sure where it originated from. Maybe I'll use it on a simulator. Definately looks different from all the other 201  yokes.

[ToddDPT]

Nice pick up Jim!