Electronics International (EI) UBG-16 Engine Analyzer + modules

[HRM]

I am selling my UBG-16 (Ultimate Bar Graph Engine Analyzer) that was removed when from my E when my MVP-50 was installed.

 

These are sold on Spruce as well as direct by EI. This is a TSO part and you send it to EI who will check it out and then reset it to the parameters of your Mooney for a fee (used to be $125). This box is EXTREMELY well-documented on the web, you can download it all and read--operating, installation, etc. Call EI and chat, they are super to work with.

 

Photos are on Flickr here.

 

UBG-16-8 • S/N055326

FM-GYRO Module (Vacuum Pressure)

FM-RPM module (RPM)

FM-OP module (oil pressure)

MUX-8A module ("Black Box" data recorder to DL data to PC or upload to "Savvyanalysis")

 

EGT/CHT sensors not included—I kept the originals for the MVP-50, this way you get all new 

 

$1,500.00 (1.5 AMU)

 

[Piloto]

Works great!. I have one in my M20J and love it.

 

José

[Wakeup]

Love to have one but that's almost what they are selling for new.

[Hank]

Just looked. $1648 new.

[HRM]

Just looked. $1648 new.

 

Looked where? Guys, add the four modules...jeez.

[Marauder]

Looked where? Guys, add the four modules...jeez.

 

Tough crowd. The 4 modules will bring the total new price to: $2489.80 plus you get new EGT/CHT probes...

[Amelia]

I have an EI UBG-16, too.  It's for a 6-cylinder engine, yellow-tagged. Wiring harness is included. No probes are included, but all the computer stuff and instruction books are. I would be delighted to get $500 for it.

[HRM]

...and off to Ebay it goes.

[Piloto]

HRM

 

You may want to consider the option of selling the UBG-16 without the modules.

 

José

[HRM]

HRM

 

You may want to consider the option of selling the UBG-16 without the modules.

 

José

 

 

I am open to all offers.

[furledd]

I have that same EI setup as you did and curious how much did it cost to get an MVP-50 installed by the time you were all done

 

I had been toying with the idea but figured it would be well over $5k ...maybe $10k by the time all those gauges were replaced... Posible to share your experience on that?

[HRM]

I have that same EI setup as you did and curious how much did it cost to get an MVP-50 installed by the time you were all done

 

I had been toying with the idea but figured it would be well over $5k ...maybe $10k by the time all those gauges were replaced... Posible to share your experience on that?

 

PM sent.