Crankshaft flange identification

[Jayhawk_aviator]

Reattaching the flywheel and spinner dome on the m20j.  There is an "O" on the flywheel and crankshaft flange to line up, but I can't see the mark on the flange.  I do see a 40 stamp on the edge of the flange, and it appears that that bushing is "stepped" at the point.  Is that the O?  Is there another way to find the O bushing?

 

thnaks 

scott

[wpbarnar]

I thought the "O" was stamped on the face of the fly wheel and face of the crank flange.  If in doubt, couldn't  you find TDC on compression for #1 cylinder and then verify the fly wheel is indexed correctly by looking at the timing marks on the fly wheel versus the dot on the starter or split line in the case?  If indexed correctly the timing marks on the fly wheel should correspond correctly with the reference marks on the engine.

Bill

[Jayhawk_aviator]

That was my question I think.  With #1 cylinder at tdc, should the tdc mark on the flywheel be lined with the arrow at the split in the case?

[Guest]

The "O" on the starter ring gear support is meant to line up with the oversized crankshaft bushing.

Clarence

[Jayhawk_aviator]

Is the oversize bushing the one that has a "step" to it?

[FloridaMan]

http://www.lycoming.com/Portals/0/techpublications/serviceinstructions/SI%201098H%20(03-08-2012)/Propeller%20Flange%20Bushing%20Location.pdf

 

Next time, take a sharpie and put a mark on things before you take them apart 

Edited March 26, 2016 by Antares

[Guest]

  On 3/26/2016 at 4:12 AM, Antares said:

http://www.lycoming.com/Portals/0/techpublications/serviceinstructions/SI%201098H%20(03-08-2012)/Propeller%20Flange%20Bushing%20Location.pdf

 

Next time, take a sharpie and put a mark on things before you take them apart 

Expand  

That works provided the last guy put it on correctly.  I've seen one where the was put on wrong and the hole was punched larger by the oversized bushing.

Clarence

[FloridaMan]

I've seen this too

Sent from my iPhone using Tapatalk