eeyore Posted November 27, 2011 Report Posted November 27, 2011 Greetings! Just before the holidays I went to look at a M20F. It is well equipped for my requirements. I took a few pictures. Here are some that concern me. Any input will be greatly appreciated. Thanks! Quote
Jeev Posted November 27, 2011 Report Posted November 27, 2011 Though those do not look like "big ticket" items I would be more concerned with what else you WILL find when you get deeper than a visual inspection. The lack of quality repairs points to a attitude by who ever is maintaining this bird of deferring and bandaid fixes. Something as simple as the gear well boot should have been fixed properly instead of a bunch of tape on top of tape.... Maybe I'm too anal but I would never let that slide on my Mooney. I'd pass unless it is a really good deal and if so have the buyers agreement be contingent on a complete annual inspection. Quote
N601RX Posted November 27, 2011 Report Posted November 27, 2011 The corrosion in the wheel wheel would concern me most. I would want to know if that is the only corrosion, or if there is more once the inspection plates are removed. Quote
eldeano Posted November 27, 2011 Report Posted November 27, 2011 dito all of the above. The 7000 series of aluminum used in our airplanes structual areas has a tendency to corrode if the heat treat on it was not perfect. The worst of this is intergrannular which usually pops up on a spar or something. exposure to an elecrolyte (water) can trigger this. The corrosion in the picture, and the areas they clearly painted over on the alcad aluminum can be taken care of by just stripping the paint, removing as much corrosion as possible and then etching with alodine and repainting with a corrosion resistant paint. But the question remains...............what lurks underneath. My experience has been where there is smoke there is fire. Especially in these older airplanes. I cant tell what is happening in the last picture, clearly there is a couple of non-stock panels, one pop-rivited it looks like, then a cut access panel with what looks like machine screws and tinnerman nuts I would assume. Modification? Quote
eeyore Posted November 27, 2011 Author Report Posted November 27, 2011 Quote: eldeano I cant tell what is happening in the last picture, clearly there is a couple of non-stock panels, one pop-rivited it looks like, then a cut access panel with what looks like machine screws and tinnerman nuts I would assume. Modification? Quote
jetdriven Posted November 27, 2011 Report Posted November 27, 2011 That rat boot with duct tape is no big deal, ours is like that. However, that wide area of corrosion or paint falling off is a concern, as is the area under the battery box where that panel is sticking out. Perhaps the aluminum was oily or not primed right and the paint is peeling. Thaata no big deal. It may be corrosion. Which is a big deal. Investigate further. What is the spec sheet and asking price for this plane? Quote
eeyore Posted November 27, 2011 Author Report Posted November 27, 2011 Quote: jetdriven What is the spec sheet and asking price for this plane? Quote
rob Posted November 27, 2011 Report Posted November 27, 2011 Are you interested in a C, by any chance? Quote
OR75 Posted November 27, 2011 Report Posted November 27, 2011 Although it is obviously not the full pre-buy inspected every buyer must do, I wonder if it is OK to ask the pilot / owner to open a few panels and have simple "visuals". I am thinking that it would be easy enough to: open the tail cone panel / battery acces and look at what is there with a flashlight remove the engine compartment top cowling and see what the engine / firewall / hoses and fittings look like open a couple of wing inspection panels Quote
eldeano Posted November 28, 2011 Report Posted November 28, 2011 If your really that interested, go ahead and do a title search, see if it has been landed on its belly. Next step is to check the logs, look for 337s (major repairs) due to structural repair, and go ahead and get a prebuy. Hopefullly it is just some surface issues and everything else is ok. You don't want to take on a project. It's always nice to find a plane that is equiped how you want it, good luck! Quote
triple8s Posted November 28, 2011 Report Posted November 28, 2011 If they would'nt let me open panels I'd walk on, it's buyers market. Quote
rbridges Posted November 28, 2011 Report Posted November 28, 2011 Quote: eeyore http://www.controller.com/listingsdetail/aircraft-for-sale/MOONEY-M20F-EXEC-21/1976-MOONEY-M20F-EXEC-21/1203269.htm? Quote
M20F Posted November 28, 2011 Report Posted November 28, 2011 About $20-$30K over priced in my opinion. Quote
Bob Posted November 28, 2011 Report Posted November 28, 2011 Quote: rbridges The asking price puts it very close to a 201, so keep that in mind. Quote
MARZ Posted November 28, 2011 Report Posted November 28, 2011 Looks like one incident Accident/Incident Occurred on: 1987-06-26 Narrative: RAN OFF RUNWAY AFTER LANDING. NOSE WHEEL STEERING HAD BEEN REPAIRED AND FELT DIFFERENT TO PILOT. Quote
eeyore Posted November 28, 2011 Author Report Posted November 28, 2011 Quote: maropers Looks like one incident Accident/Incident Occurred on: 1987-06-26 Narrative: RAN OFF RUNWAY AFTER LANDING. NOSE WHEEL STEERING HAD BEEN REPAIRED AND FELT DIFFERENT TO PILOT. Quote
mooneym20d Posted November 28, 2011 Report Posted November 28, 2011 There are far better deals out there for what that plane offers at the asking price. The corrosion concerns me as well as the sloppy paint and panel installation. I agree with Bob and Rob. For that price, I would look at the J's. Quote
stevesm20b Posted November 28, 2011 Report Posted November 28, 2011 I think that is too much money for an "F" model, especially one in that kind of shape. I also agree you could probably find a J model for that kind of money. Quote
Shadrach Posted November 28, 2011 Report Posted November 28, 2011 That thing is way overpriced... It clearly has not been maintained to the standards required to command such a high price. At that price level, I would expect a fully modded and well care for AC. Quote
richardheitzman Posted November 28, 2011 Report Posted November 28, 2011 That slopped on paint job in the wheel well is classic "I am hiding something I don't want you to see." There are weeping rivets in the upper area that need to be closely looked at. There is also bubbled paint forward and inboard that also needs closer inspection. To me, this is all classic signs of neglect. Just walk away and keep looking. Quote
1964-M20E Posted November 28, 2011 Report Posted November 28, 2011 I think I’d pass on this one at $76k maybe in the $40 to $50k range and as stated above if you are in this ballpark for $ go for a 201. I know where you can get a 74 Arrow I know this is a Mooney board (20 lashes with a wet noodle for me) but my neighbor is selling his Arrow II with brand new pant and interior the plane is lacking on avionics though but could be had in the $60k range. Unfortunately he is giving up flying he does not use his plane enough. Quote
eeyore Posted November 28, 2011 Author Report Posted November 28, 2011 Thank you all for your input. There are indeed plenty of better planes. Unfortunately, very few are listed in my neighborhood ( GA, SC, NC, northern FL.) Quote
rbridges Posted November 28, 2011 Report Posted November 28, 2011 Quote: eeyore Thank you all for your input. There are indeed plenty of better planes. Unfortunately, very few are listed in my neighborhood ( GA, SC, NC, northern FL.) Quote
n6773v Posted November 28, 2011 Report Posted November 28, 2011 We have a real clean F model posted on the board at KIPJ near Charlotte,NC. I will get the information tomorrow and post. Quote
Jeev Posted November 28, 2011 Report Posted November 28, 2011 It's worth a couple hundred bucks to fly commercial to take a look. If you widen your search you will find a better plane.. Also 2 years ago I paid 88k for my J. You can definitly find a better deal. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.