Looking for a small six wire connector

[xcrmckenna]

Trim switch has stopped working again. The down trim micro switch crapped out. This time the hangar fairy is looking to install a six wire connector where the wires come out of the left side yoke handle and goes into the yoke shaft.

 

I want the smallest six wire connector I can find, so it doesn’t get in the way and rub on my leg or knee pad. I’m going to use 24 gauge wire to get as slim of a connect I can find.

 

 

Sent from my iPhone using Tapatalk

[chriscalandro]

6 pin Lemo. 
 

also,

are you sure you want to use 24g for that?

Edited July 17, 2020 by chriscalandro

[N201MKTurbo]

I would look at mil-dtl-83513 connectors.

[larryb]

I would use a mini molex plug. Or a d-sub if you can handle the shell size.

[xcrmckenna]

6 pin Lemo. 
 
also,
are you sure you want to use 24g for that?

Dang I didn’t even think about a Lemo connector. I ordered a deutsch connector. I decided to go with the 20g. If this doesn’t work then I’ll use a Lemo connector.


Sent from my iPhone using Tapatalk

[xcrmckenna]

I would use a mini molex plug. Or a d-sub if you can handle the shell size.

I didn’t realize they made a mini molex plug. That might work. I ordered a deutsch connector and see how that works out first.


Sent from my iPhone using Tapatalk