Jump to content

Recommended Posts

Posted

I would appreciate if someone with a Mid body and a lower beacon could take some measurements of the location of the beacon, I would appreciate it.

I would like to add a beacon.  1)  It is a good safety thing for ground ops to let people know that the engine is running or about to run.   And 2), if you leave it on all the time, a quick glance as you walk away lets you know you turned the master off. :)

 

Posted

If you get one of the new LED beacons, which are really just red strobes, they are so small, you could put them just about anywhere. I would pick a location that has good visibility and easy access to the wires.

Posted

Not quite measurements, but at least you get a sense of where my beacon is located.  A couple of rivets were new and painted over from AP servo install.  But beacon was original install location, just replaced with LED.

Marc.

IMG_6284.jpg

IMG_6285.JPG

IMG_6286.jpg

Posted

Mine is just forward of the static port but I think it’s more of just keeping it away from servos brackets. So I think you have a fairly wide fore-aft area to place it. And it’s also not on the center line but more on the right of center. 

IMG_8002.jpeg

  • 1 year later...
Posted

Not sure when the tail will be open, but I will try to remember to get a shot when it is.

What are you looking for?

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.