M20A Brake Cylinder or push rod

[Steve Smith]

Hi me again, looking for info on where I could find a brake cyl or a rebuild kit. The push rod on the right side is worn out of limits causing the fluid to seep past the new o ring. I would like a new rod or a complete master if possible 

I appreciate the help ! It really takes a community to keep these old girls fit

[carusoam]

See if @M20Doc has M20A details...

Best regards,

-a-

@Steve Smith see doc’s note below...

[Guest]

Not sure of the manufacturer, but it’s item 29.

Clarence

[mike20papa]

Steve, I rebuilt the master cly.s on my '59 A model a few years back and so looked at the record photos I take.  Looks like you might be able to take a long an3 or 4 ( can't tell from the photos) and modify it to replace the actuating rod.  I guess what your saying is the the seal is no longer tight around the rod diameter.  Best of luck.  Joe N8335E

[47U]

Here’s a link to previous discussion that might be helpful with replacement options...

 

[Steve Smith]

10 hours ago, mike20papa said:

Steve, I rebuilt the master cly.s on my '59 A model a few years back and so looked at the record photos I take.  Looks like you might be able to take a long an3 or 4 ( can't tell from the photos) and modify it to replace the actuating rod.  I guess what your saying is the the seal is no longer tight around the rod diameter.  Best of luck.  Joe N8335E

Yes that is the issue the steel shaft has become worn and the o ring wont seal tight. I was thinking I could make a new shaft thank you for the photo