Jim5895 Posted August 24, 2018 Report Share Posted August 24, 2018 My M20E landing gear retracting mechanism has a bracket (part # 560024-7) which has a 'wallowed out' (technical term) 1/4" hole. The 1/4" bolt through the hole is the pivot for a belcrank. The bracket attaches to the main spar with Huck lockbolts. Is there a bushing kit or procedure available for fixing the bracket? Quote Link to comment Share on other sites More sharing options...
Don Heene Posted August 24, 2018 Report Share Posted August 24, 2018 I replaced my Gear down block last year it was a little hard to get into the new block, after using tri flow worked fine. Quote Link to comment Share on other sites More sharing options...
ShuRugal Posted August 24, 2018 Report Share Posted August 24, 2018 6 hours ago, Jim5895 said: My M20E landing gear retracting mechanism has a bracket (part # 560024-7) which has a 'wallowed out' (technical term) 1/4" hole. The 1/4" bolt through the hole is the pivot for a belcrank. The bracket attaches to the main spar with Huck lockbolts. Is there a bushing kit or procedure available for fixing the bracket? I would expect that the "standard procedure" is to bore the hole out to the next standard 1/4"-ID bushing size (remaining material permitting) and then weld in a bushing. 1 Quote Link to comment Share on other sites More sharing options...
Andy95W Posted August 25, 2018 Report Share Posted August 25, 2018 Call LASAR, they have PMA'ed oversized bushings for all the landing gear pivot points. If it isn't bushed, then they can weld/repair your part. Quote Link to comment Share on other sites More sharing options...
lamont337 Posted August 25, 2018 Report Share Posted August 25, 2018 This? 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.