Thackett Posted October 12, 2020 Report Posted October 12, 2020 Looked through the Mooney manual no torque specs on the nose gear truss to the spindle or retract truss to the airframe. Is everyone using the standard torque specs for the bolt size ?
carusoam Posted October 12, 2020 Report Posted October 12, 2020 See if @M20Doc is around (for proper torque question...) Best regards, -a-
Guest Posted October 12, 2020 Report Posted October 12, 2020 (edited) Bolt #3(not the circled bolt 2, my error) the trunnion pivot bolts are torqued to standard values for AN bolts. Bolt #10 is subject to S/I M20-109 or the torque specified if it has a LASAR oversized bushing STC. Clarence Edited October 12, 2020 by M20Doc
carusoam Posted October 12, 2020 Report Posted October 12, 2020 @Thackett your torque questions have been answered... See doc’s post. -a-
PT20J Posted October 12, 2020 Report Posted October 12, 2020 I torqued bolt 10 according to the SB and the steering was very stiff. I backed it off one position on the castilated nut ant it was much better. Skip
Recommended Posts