Lood Posted February 13, 2009 Report Posted February 13, 2009 Apart for the couple of "newer" instruments, my Mooney still has the two roof mounted lights for panel illumination. I'm planning to upgrade that in the near future, but there seems to be a lot of different types of panel lighting options available. In my previous airplane, I had the small lights that replaces one of the instrument retaining screws. These worked quite well, but I've seen another type I like more. They are basically a ring that is placed between the instrument and the panel. I would appreciate any recommendations and advice on this from anyone that does night flying. Quote
N9240M Posted February 13, 2009 Report Posted February 13, 2009 I too am looking for panel light options. I still have the old style panel with the crappy plastic overlay, with post lights attached to the plastic, not the panel itself. It's awful. I would like to ditch the post lights and go to the NuLite ring lights, as this also gives me future flexibility when I convert my panel to a 201 style, as I can continue to use the NuLites and not lose that investment. I also plan to fabricate my own overhead panel and console, and ditch the crappy old spot lights and rheostats in favor of a solid state dimmer (compatible with the NuLites). Another option, though not sure if it would fly with the FSDO, is a strip LED under the glareshield, illuminating the entire panel. Quote
The-sky-captain Posted February 14, 2009 Report Posted February 14, 2009 I've got the strip under the glareshield and it works great Quote
FlyDave Posted February 14, 2009 Report Posted February 14, 2009 I installed Nu-Lites in my Cherokee and I think they are GREAT!! I installed a reostat and can turn them up bright enough to read charts and turn them down low enough so that on a moonless night over the desert the illumination level is perfect. I'll be buying a Mooney soon and if it doesn't have Nu-Lites, I'll install them. Quote
N207LS Posted February 15, 2009 Report Posted February 15, 2009 Nu-Lights are the way to go... I had them installed around each of my instruments (except the two that were back lit) when I did my panel upgrade and attached all of the to the dimmer all ready in the plane for the roof mounted lights. I still have the roof lights (3 red lights adjustable on posts), but the nu-lights are great. I now can put the red roof lights down on the trim and flap indicator, and use one for each pilot and co-pilot as chart lights. It is really nice not to have to fish around for a flashlight all of the time at night. Aaron Quote
flhelo Posted August 10, 2010 Report Posted August 10, 2010 Aaron, How difficult was it to wire into the overhead dimmer? Larry Quote
carusoam Posted August 10, 2010 Report Posted August 10, 2010 Larry, From my M20C experience.... There is a readily available post for all things to be dimmed under the left side of the instrument panel. The dimmer switch is up in the ceiling, but the "wire to" position is only a short distance from your instruments. There should also be a single light bulb aimed at the fuel selector switch very near by this post. Of course, you should probably have your A&P / electrician helping you with this one. Overall it is very easy since most of the new lights that are avilable are LED and draw very little electricity. Best regards, -a- Quote
Barry Posted August 10, 2010 Report Posted August 10, 2010 Remember that LED's do not draw enough current to dim with the old rheostat. To keep the old rheostat, you must either have a bulb somewhere in the circuit or a resistance to ground to draw enough current through the rheostat to setup the voltage gradiant. This definately requires a licensed individual to do the work. Quote
N5MD Posted August 11, 2010 Report Posted August 11, 2010 Wanted: old spot lights from your Mooney A previous owner removed the 'crappy old spot lights' from my Mooney and I want to replace them. Contact me if you have a pair you're not using (vincentkdunn@yahoo.com) Quote
MARZ Posted August 2, 2011 Report Posted August 2, 2011 Quote: N5MD Wanted: old spot lights from your Mooney A previous owner removed the 'crappy old spot lights' from my Mooney and I want to replace them. Contact me if you have a pair you're not using (vincentkdunn@yahoo.com) Quote
N5MD Posted August 2, 2011 Report Posted August 2, 2011 Mike, No, I never got a 'hit' on replacing my missing ceiling lights. Do you have a lead for me? I'm still looking. Vincent (vincentkdunn@yahoo.com) Quote
MARZ Posted August 2, 2011 Report Posted August 2, 2011 no leads - I was hoping you may have an extra. Found them - for the bargain basement price of 125 each..... sheeze. Quote
N5MD Posted August 4, 2011 Report Posted August 4, 2011 Mike, I'm even interested at $125 ea. Where did you find them? (vincentkdunn@yahoo.com) Quote
jbreda Posted August 4, 2011 Report Posted August 4, 2011 I am finishing up my avionics install and have some Nu-Lite rings left over. I am not sure how many I have but I can check. They are standard instrument size. If interested please contact me at johnabreda@yahoo.com Thanks. John Breda Quote
kurtsnyder Posted August 5, 2011 Report Posted August 5, 2011 I'm not sure if this is the same things, but Spruce has them for much cheaper at $43.95 per light: http://www.aircraftspruce.com/catalog/elpages/nulite.php If you do a google image search for "Nulite panel lights", it's amazing how much better a panel looks and how much easier it is to see the gauges with them installed. This is going to be one of the first things I do when I get my Mooney. Quote
MARZ Posted August 5, 2011 Report Posted August 5, 2011 Quote: N5MD Mike, I'm even interested at $125 ea. Where did you find them? (vincentkdunn@yahoo.com) Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.