What’s old is new again

[Rjfanjet]

I’m looking to make a 6 pack out of my current panel. Where can I find a blank right and left panel?

1968 C

Thanks

[chriscalandro]

Probably needs to be custom made for your airplane.  Why do you want to do this?

[gsxrpilot]

https://www.eapanels.com

https://www.knr-inc.com/2014-07-13-01-32-38/instrument-panels/20-manufacturing/55-1ip-mooney-pre1969

https://store-hendricksmfg-com.3dcartstores.com/Custom-Instrument-Panel--Engineering-Deposit_p_52.html

[Rjfanjet]

I stare at glass all day for work. I just want the classic look. 

[Hank]

Check here, too. Looks like some of these will work.

 

[Greg Ellis]

I bought my new panels from LASAR for my 1963 C model.  The pilots side had the 6 pack, actually 8 holes already cut and the co-pilot side was a blank.  The panels were not listed on their website.  I had to call them.  Very little trimming was needed.  The notches for the yokes, etc...were already cut out and fit just fine.

 

[0TreeLemur]

Cut this one using a water jet from a .dxf file.  Bent it to match the angle of the old panel.  Note: this arrangement requires a tapered shim to make the DG parallel to the yoke shaft and prevent interference.   We 3-D printed a shim and field modified it to fit as shown.  

 

Edited December 15, 2020 by 0TreeLemur
Added note.