EDM730 not displaying EGT values, only CHT

[bcbender10]

Hi all,

My EDM730 display does not show numerical values for EGTs. It only shows CHTs and TIT. How do I "turn on" the EGT value display? 

Thanks.

Edited March 8, 2020 by bcbender10

[ArtVandelay]

It’s been a while, but I think go into programming mode by holding down LF and step buttons. If not on the first list, you go into a second list.

[bcbender10]

THanks. The only mention of EGTs I could locate is display EGT to 1's (vs. 10 degree increments)

[bcbender10]

Update: the display issue is not related to the new parameters the MSC added. here's a pic of the EDM730 display before the work. 

The EDM730 manual shows the CHT bars should be white, and the CHT temps white. In my set up, both are green. Is that a clue? 

Possibly relevant is that the EDM730 is an upgrade from an EDM700 which was factory installed. EGTS are showing in the rotating displays on the bottom of the screen and are properly recording and downloading via the USB port.

Here's a pic of the display before the new parameters were added:

Edited March 9, 2020 by bcbender10

[Hector]

Once I had my 730 not behaving right and I downloaded the latest firmware and it corrected the problem. If you do that go to settings first and write down the k value for the fuel flow transducer as you will have to input that after the firmware upgrade. I’m not saying this will fix it, only something to consider if your firmware is not the latest


Sent from my iPad using Tapatalk