Bob_Belville Posted September 26, 2015 Report Posted September 26, 2015 name="piperpainter"]you can just get ride of the step....it'll save you a few pounds too! I could get along without the step. But Nancy and probably other passengers would not be able to get along without it. Sent from my XT1060 using Tapatalk
Steve65E-NC Posted September 26, 2015 Report Posted September 26, 2015 My turn and bank is 2.25 and no room for larger without new panel. As I understand the minimal paper work replacement must be the same size. Anything out there that will fit and work.
Jerry 5TJ Posted September 26, 2015 Report Posted September 26, 2015 My turn and bank is 2.25 and no room for larger without new panel. As I understand the minimal paper work replacement must be the same size. Anything out there that will fit and work. This will fit right in to the little 2.25 inch opening. http://www.chiefaircraft.com/rca-2600-2.html
Steve65E-NC Posted September 26, 2015 Report Posted September 26, 2015 OK, but isn't a ball needed for this to qualify as replacing turn and bank??
jetdriven Posted September 26, 2015 Report Posted September 26, 2015 yes but they will sell you a 200$ skid ball that bolts to the front of the unit. Why they didnt put that on the screen IDK 1
1964-M20E Posted September 28, 2015 Report Posted September 28, 2015 Why the qualified "single function"?? Doesn't this exclude Apsen,Garmin PFDs? I think another aspect it is classified as a minor alteration. If you go multi function you are now connecting into the pitot static system as well. Where as the single function AI you cap the vacuum source and install a CB and you are good to go.
Recommended Posts