7.Mooney.Driver.0 Posted September 29, 2018 Report Posted September 29, 2018 Hi everyone. Im trying to find a pin out for the pane lighting control, previous owner took all the wires out of the connector and didn’t label any of them Thank you all in advance. Sent from my iPhone using Tapatalk Quote
RLCarter Posted September 29, 2018 Report Posted September 29, 2018 Isn't that the pin on the page that it's opened up too? Quote
Guest Posted September 30, 2018 Report Posted September 30, 2018 2 hours ago, siu1526 said: Hi everyone. Im trying to find a pin out for the pane lighting control, previous owner took all the wires out of the connector and didn’t label any of them Thank you all in advance. Sent from my iPhone using Tapatalk Model and year? Clarence Quote
Hank Posted September 30, 2018 Report Posted September 30, 2018 This is why I've never understood aviation using all white wires for everything! There are dozens of wires behind my panel, and every last one is white . . . . It's not like that at work. Quote
RLCarter Posted September 30, 2018 Report Posted September 30, 2018 7 minutes ago, Hank said: This is why I've never understood aviation using all white wires for everything! There are dozens of wires behind my panel, and every last one is white . . . . It's not like that at work. Me either, i'm a black & white kinda guy but I do like a little color in my wiring Quote
MikeOH Posted September 30, 2018 Report Posted September 30, 2018 With a schematic to the box you can manually trace each wire and figure out which pin goes where in the connector block. Pain in the arse, but that's likely what you need to do. The wires MAY be labelled (they are on the wires going into the mating connector block, but I'm not sure about the wires in the control box itself. PM me if you need the shematic. Quote
larryb Posted September 30, 2018 Report Posted September 30, 2018 The wires generally have the circuit number printed on them. From what I can see in the pic these wires are labeled. So it should be possible to re-pin the connector. But what a pain.... Quote
Yetti Posted September 30, 2018 Report Posted September 30, 2018 ^^^^^ wires should have the circuit label on them Quote
7.Mooney.Driver.0 Posted September 30, 2018 Author Report Posted September 30, 2018 Hi guys thank you all for the input. After further examination i realized that there where letters stamped on the wires those letter correspond to the letters stamped on the plug. After everything was all set and done i only have two wires i don’t know their location, it looks like they were replaced and no one bother marking them. Sent from my iPhone using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.