Fastener issue...

[HRM]

This is a fastener off my empennage access panel and there is a small washer that holds it to the panel that has flown off somewhere. Any suggestions on how to replace the washer (like, what it's called), or do I need a whole new fastener? 

[KSMooniac]

Look up Dzus fasteners. Not sure if you can buy a new clip or not.

Sent from my LG-LS997 using Tapatalk

[carusoam]

Consider Sending the same question over to Aircraft Spruce.  Sometimes they respond positively.  Expect somebody rebuilding their plane has the same need only 100 times more.

Best regards,

-a-

[jaylw314]

It's hard to tell from your photo, but it looks like one of the camloc 2600 fasteners.  They are retained with a split washer 2600SW2 you need to bend and straighten to get on

http://www.aircraftspruce.com/catalog/hapages/camlocwashers.php

[HRM]

13 minutes ago, jaylw314 said:

It's hard to tell from your photo, but it looks like one of the camloc 2600 fasteners.  They are retained with a split washer 2600SW2 you need to bend and straighten to get on

That should work, thanks for the link!

[Guest]

That's a Southco Fastener from the avionics hatch on the left side.  the lock ring is a S1115-9 from Spruce.

Clarence

http://www.aircraftspruce.ca/catalog/hapages/04-00285.php?clickkey=3020031

[HRM]

Ok, the PM says "82-32-101-17 RING, SPLIT", but these apparently are made of unobtainium.

Spruce has a "#82 SOUTHCO retainer" which is a split ring (82-32-101-20) in SS.

So I am guessing that the originals were not SS and the 17→20 in the P/N is just the same washer but now in stainless?

I could not find the original P/N anywhere, but I frankly don't care what they are made of as long as they fit and keep the little bugger with the panel 

[HRM]

OK, never mind...Mooneyspace is so therapeutic:

SOUTHCO DZUS #82: