All Activity

This is the pop-up add that Was confusing as you first navigate this site. With the request for photo, profile questions, sustaining membership possibly and this pops in. They got me to click. Almost as if they knew I was Newbie but didn't know it yet.

I have the same one - on the IO360 it’s quite a ways up the tube and you have to give the supply tube a good shove to get up past the ice hole. I have the tube marked so I know how far to put it - I did that when I changed the oil. Buy a few jugs of dessicant in order to swap it out when it’s turns pink, so you can bake the used stuff at your leisure. baking the dessicant is a pain. I probably should have gone for the Drybot instead. Those guys were in the booth next to me at Oshkosh for the last two or three years and it’s a nice product.

Yet another case with plenty of options. Thankfully they survived.

Hello, Looking for used: - GNS non-WAAS NavData Card (green label), 8Mb Regards, AVDB

Holy Micro! LLC has added more reminders and enhanced smartphone like Bluetooth connectivity for the SkyVoice Alert 500 and SkyVoice Glassy Guide 400, helping pilots fly safer and easier by reducing cockpit workload and preventing gear-up landings. SkyVoice Alert 500 – Smarter Altimeter with Intelligent Algorithms The SkyVoice Alert LHA 500 combines LiDAR technology with next-generation algorithms and includes customizable reminders, Bluetooth connectivity, and a proximity-based gear warning system for improved safety during takeoff and landing. In its Advanced Mode, the system added more reminders, pilots can set additional reminders in AGL, MSL, and Run-Time categories; enhanced Bluetooth connectivity for seamless smartphone-like wireless pairing; and direct headset integration. Combined with an improved software algorithm featuring signal noise suppression and smoothing, these upgrades ensure more accurate altitude readings and timely alerts. This integrated setup allows pilots to receive real-time altitude announcements and safety reminders directly in their headsets, minimizing distractions and enhancing situational awareness throughout every phase of flight. Key Features of SkyVoice Alert 500: · LiDAR range of 590ft. · Continuous Gear warnings from 560ft until the Gear is down & locked. · Takeoff announcements from 10ft to 500 ft. · Landing announcements: 500ft to 1 ft. Expanded user selectable reminders: Check Gear, Checklist, LC GUMPS, Flaps, Speed, Clearance, Prop, Pump, Check Cabin Pressure, Check FF RPM OP MP, Check Fuel Flow, Check Power etc... · Run-time reminders: Check Tank, Check Carb Heat, Check FF RPM OP MP, Check Fuel etc… · GPS/MSL announcements with reminders from 18,000 ft to 500 ft, Reminders like Check Oxygen, IFR Altimeter, Clearance, Prop, Top of descent, Check Cabin Pressure, Check FF RPM OP MP, Check Fuel Flow, Check Power etc… · Bluetooth or wired connectivity SkyVoice Glassy Guide 400 RADAR Altimeter for Amphibians The SkyVoice Glassy Guide 400 is a RADAR-based Takeoff and Landing Height Announcer built specifically for seaplanes and amphibious aircraft. It provides accurate AGL readings up to 400 ft, even over glassy water, where depth perception is most difficult. In its Advanced Mode, the Glassy Guide 400 adds more reminders in AGL, MSL, and Run-Time, along with enhanced smartphone like Bluetooth pairing, giving pilots additional options for receiving altitude callouts and reminders. Key Features of the SkyVoice Glassy Guide 400: · Radar range of 400 ft. · Takeoff announcements from 50ft to 400 ft. · Landing announcements from 400 ft to 1 ft. · User selectable reminders, including Clearance, Check Gear, Checklist, Check Cabin Pressure, Check FF RPM OP MP, Check Fuel Flow, Check Power, Speed, Flaps, Pump, LC GUMPS, Gear Up for Water Landing, Prop etc… · Four customizable gear reminders · GPS/MSL announcements from 18,000 ft to 500 ft with user selectable reminders like IFR Altimeter, Check Oxygen, Clearance, Prop, Check Cabin Pressure, Check FF RPM OP MP, Check Fuel Flow, Check Power etc… · Run-time reminders: Check Tank, Check Carb Heat, Check FF RPM OP MP, Check Fuel etc… · Portable version available with rechargeable battery, Bluetooth connectivity, and the same internal hardware as the certified unit—ideal for testing before permanent installation. Holy Micro! LLC is redefining aviation safety with LiDAR and RADAR altimeters, Absolute AoA technology, and pilot-focused innovations.

I have done some of these, it's not practical (many places have tons of rules on noise). Sometimes it's what one needs to do in places where options ahead are limited with built up areas ahead, the majority of these places down here already require 45deg turn right after departure from runway axis as "normal noise departure"... Flying tight pattern with steep angle (less power) is also helpful, although, this skill is not longer in fashion as pilots are taught from day 1 to fly "wide B52 bomber patterns" on "PAPI/VASI using 3deg glide" with "stable approach". Anyway, tight departure and tight pattern helps when flying VFR: one day as one will need it, as we say, it's good to invest in own luck rather than waiting for surprise ! Then there is IFR flying: prescribed SID or ILS paths or low vectoring, especially IMC, not much choices than keeping straight wing level, on sensible speed, and hope for the best...

Someone I know was in this exact state a while ago in an M20E. It took a few months to get a new pump so he was flying it around without an issue. To start cold it, it takes a bit more battery. Full rich, cracked throttle and then crank. It takes a few turns to build fuel pressure, then 5 seconds later it should start. You might have to crank to pressure, rest the starter, then start it. While you are at it, make sure you change your post to have it on record that the pump is still working and you are only asking for information. Mechanical pumps rarely fail, and many people have electric backup pumps that are not rated for continuous duty and probably won't get them very far, so I don't see much increased risk. Information for ground starting purposes only :p

My 71E came with an Owner's Manual rather than POH, and the only chapters that are FAA-approved and regulatory in nature are Limitations and Emergency Procedures. Balked landing procedure is under Normal and therefore merely advisory. I guess I'm lucky.

Sounds more like Laceration 101 . . . lol.

easy to answer that. Ask for the exact part number of the KX-165 and check what indicator you have. The install manual of the KX-155/165 is easy to find online

Um...that's awesome!! I would love one! I think it was called the Mark 21 through 1967, and the Ranger name appeared for 1968 model year. Based onmy serial number 680002, I have the 2nd "Ranger". And who are you calling ugly?! Let me know what I can do to make it worth your while to send one my way.

Where did she find them? At a yard sale there in Kerrville?

The “legal” answer, is do what it says in the POH for your model and year. It’s worth noting that in both cases, flaps are retracted before gear.

I would. I'll PM address.

She also found two of these ashtrays. They do not say a model, or any other identification for that matter, but they are definitely '60's. I will keep one. Would anyone like the other?

Those are cool, @Mcstealth! By sheer coincidence, I've owned my Mooney Ranger for 18 years now . . . But I've never seen one of these.

If the idea is to run the engine on the ground, start cranking with mixture at idle cut off and slowly advance mixture while continuing to crank. Be patient. I wouldn't fly with an INOP boost pump.

I have heard that in recent times JPI will do the re-program and e-mail it to you rather than having to send it back. Then you just plug into the usb port. Not sure of the cost though.

I would love one!!

Aero motors could likely have a replacement to you in less than a week, they are probably half the cost of a new one and build in improvements the original fuel pump lacked. Give them a call!

Check out what my wife came across!! Authentic 1960 something Mooney Ranger Swag!! She found a total of ten. Six of which are in their original wrapper, ugly as they are. Would anyone like one? Sincerely David.

I think the built-in CDI function didn't come out until the KX165A somewhere in the 2nd half of the 1990's. I believe the KX-165 just had the current radial feature.

I’ll go out to the airport Thursday morning and check if I have channels above 135.00.

Sorry to hear this. But better than having an engine failure! At least you got some hours and over 12 years out of it. Thread drift warning! I've heard that the worry with loss of the clamping pressure runs the risk of spinning a bearing insert. But I've never quite understood that. Don't the inserts have tangs that 'locks' them in place in the case like automotive bearing inserts? Or, do they only rely on the friction provided by sufficient clamping?

Yes, indeed. I had to replace it recently (that is why I had the reference handy). It is not that difficult to do.