annunciator light bulbs part numbe on 78-79 M20J

[Vref]

For the 78-79 M20J drivers. Looking for a part number or voltage/current rating for the bulbs used in warning annunciator panel...

My LO VAC is U/S

They are soldered and not the GE330 type...

sorting out the minor to do stuff..now

Anyone..?

Thanks

-L

[Vref]

hhhmhmh..nobody..it looks I will have to reverse engineering here..;-)

[kortopates]

Luc

I htink your J uses the same annunciator as my K except in a 14v version. My Mooney IPC for the K model uses a CM7327 bulb, which I found at Mouser (95 cents each) when I had the same problem a few years back - you probably just need the 12v version of the otherwise same bulb, See your IPC and/or the Mouser info on mine at http://www.mouser.com/Search/ProductDetail.aspx?R=7327virtualkey60600000virtualkey606-CM7327 and you should be able to find the correct one you'll need and perhaps from a supplier in Europe. These aren't soldered to the board, eventhough I though the same thing, till I realized they pull out and push in.

[Vref]

Quote: kortopates

Luc

I htink your J uses the same annunciator as my K except in a 14v version. My Mooney IPC for the K model uses a CM7327 bulb, which I found at Mouser (95 cents each) when I had the same problem a few years back - you probably just need the 12v version of the otherwise same bulb, See your IPC and/or the Mouser info on mine at http://www.mouser.com/Search/ProductDetail.aspx?R=7327virtualkey60600000virtualkey606-CM7327 and you should be able to find the correct one you'll need and perhaps from a supplier in Europe. These aren't soldered to the board, eventhough I though the same thing, till I realized they pull out and push in.

[Vref]

for those living in Europe this is the incandesent light for 12V Farnell Electronics has them:

http://be.farnell.com/jsp/search/productdetail.jsp?sku=1139333

 

LAMP, T1.3/4, BI-PIN, 14V, 1.12W; Supply

7382