ADS-B error message on GTN650

[helitim]

The following message occurred twice this week on a trip thru SoCal while IFR over the San Gabriel Mtns. Any ideas why? Edit: A GDL 88 is also installed so, I don't think this should be an issue of activating the stations.

[larryb]

I have also seen that message, and also over Southern CA. I was around Victorville I think. The message stayed active a few minutes and went away. I have a GTN650 + GDL88.

[Marauder]

http://www.manualslib.com/manual/577371/Garmin-Gtn-6xx.html?page=63

Sent from my iPad using Tapatalk

[donkaye]

The following message occurred twice this week on a trip thru SoCal while IFR over the San Gabriel Mtns. Any ideas why? Edit: A GDL 88 is also installed so, I don't think this should be an issue of activating the stations.

 

Initially when I had my panel upgraded I was getting both 1090 and UAT receiver faults.  Garmin replaced the GDL 88.  Since that replacement I have received 1 1090 fault.  I wish I knew what they meant but they apparently aren't good, since the manual says to return the unit to Garmin for service..

[MB65E]

Had it once on a GTN 650 helicopter in SoCal (west bound Ontario area). Went away, but checked the setup IAW with the STC protocalls...

-Matt

[larryb]

Just saw this again. Guess where? Yup, Southern California coming into Fullerton.

[helitim]

My avionics tech contacted Garmin regarding this error message. They stated it is in fact a station problem related to that station in SoCal and not a hardware/software problem with the GDL88.

[larryb]

Saw it again today in SoCal on my trip KFUL to KTRK

Sent from my iPad using Tapatalk