Gear Retracting Mechanism

[Jim5895]

My M20E landing gear retracting mechanism has a bracket (part # 560024-7) which has a 'wallowed out' (technical term) 1/4" hole. The 1/4" bolt through the hole is the pivot for a belcrank. The bracket attaches to the main spar with Huck lockbolts. Is there a bushing kit or procedure available for fixing the bracket? 

[Don Heene]

I replaced my Gear down block last year it was a little hard to get into the new  block,  after using tri flow worked fine.  

[ShuRugal]

6 hours ago, Jim5895 said:

My M20E landing gear retracting mechanism has a bracket (part # 560024-7) which has a 'wallowed out' (technical term) 1/4" hole. The 1/4" bolt through the hole is the pivot for a belcrank. The bracket attaches to the main spar with Huck lockbolts. Is there a bushing kit or procedure available for fixing the bracket? 

I would expect that the "standard procedure" is to bore the hole out to the next standard 1/4"-ID bushing size (remaining material permitting) and then weld in a bushing.

[Andy95W]

Call LASAR, they have PMA'ed oversized bushings for all the landing gear pivot points.  If it isn't bushed, then they can weld/repair your part.

[lamont337]

This?