matthew_william Posted August 10, 2016 Report Posted August 10, 2016 Does anyone have ideas for a removable armrest for a 1966 M20E that can be dropped into place during cruise? This would be something that would fit over the J-bar landing gear extension handle and would fit snugly between both front seats. Any existing products? Homemade designs? Thanks in advance. 1
RLCarter Posted August 11, 2016 Report Posted August 11, 2016 Looking for the same, mainly for drink holders for the front and back seats, a small compartment would also be nice.
Bob_Belville Posted August 11, 2016 Report Posted August 11, 2016 Check out seats from typical Airbus coach section mechanism. Of course the Mooney seat is wider.
Hank Posted August 11, 2016 Report Posted August 11, 2016 2 minutes ago, RLCarter said: Looking for the same, mainly for drink holders for the front and back seats, a small compartment would also be nice. I out my water bottle on the floor between the seats, all the way back against the back seat. Leaves between the seats free to put charts waiting for use, and to keep a snack handy on longer trips. My hand swings naturally back to the bottle position. No cupholder required! But then again, I leave my Yeti in the hangar, it's not an aircraft-friendly design. Ditto my other coffee mugs and drinking containers.
carusoam Posted August 11, 2016 Report Posted August 11, 2016 You might try searching for cup holders. Best regards, -a-
Guest Posted August 11, 2016 Report Posted August 11, 2016 On August 10, 2016 at 4:06 PM, matthew_william said: Does anyone have ideas for a removable armrest for a 1966 M20E that can be dropped into place during cruise? This would be something that would fit over the J-bar landing gear extension handle and would fit snugly between both front seats. Any existing products? Homemade designs? Thanks in advance. How will you access the trim wheel? Clarence
Recommended Posts