201Mooniac

According to the install manual, if you have a GI 275, then the GTX 345 Bluetooth is supposed to be disabled. I haven’t tried it but the FS 510 is supposed to pass the “best” AHRS data, either from the G500 or the GTX 345 to the iPad (the G500 will always be better data) as both should be available to the GTN over HSDB. I’m curious why you connect to the GI 275 to upload databases as opposed to using database sync? Also, I don’t know what you mean by only the FS-510 and GTX 345 setup as Connext devices with the G500, to the best of my understanding, there is no setup on the G500 for connext devices (unless you install the FS-510 in the G500TXi which isn’t recommended). Any Connext device will pass data but there should only be one active at a time.

You can’t be connected to both the GI 275 and the GTX 345 at the same time. The GI 275 should provide GPS position, ADS-B traffic and weather, AHRS, flight plan exchange, and database concierge (with some caveats) so there is no reason to try to connect to the GTX 345. In fact, you likely don’t need the FS 210 anymore given the current GI 275 capabilities. One point though, I use Garmin Pilot so I’m not sure that all of these capabilities work with FF but they are available from the GI 275, at least with the current up to date software.

Scott, I’m away for the holidays but will be happy to respond when I get back and let you know which ones I have left. Likely next Sunday or Monday.

I also have a couple of switches left from my 14V 1980 M20J, I’ve sold some of the more popular ones already.

I have red collars on AP & trim, yellow on gear actuator in case I need a manual extension.

Max, I always collar with AP breakers with a red collar so they are easy to find. I've never had to but I expect I could even get a right seat passenger to just pull the red breakers if it took both of my hands on the yoke. I think your callouts would be especially helpful in flying another plane than my own, I'll need to remember that.

Don, Glad to hear you were able to get it unjammed and land safely. I'll need to get Mark to check on that for me as my plane is in for annual right now. Great to know the AP worked but I'm curious if there is any chance it made the situation any worse when disabled. I know the servo should be easily overpowered. I have run my trim full nose up and nose down when on the ground and never had any issues, not sure if air loads have an impact but I might ask you to go for a flight where we test controlability at both extremes just so I know what to expect.

My broker thought it likely based on experience but you never know, it is business and can change at any moment.

Same experience for the last 30 years for me, same broker, almost always the same insurance company (especially for the last 8 years or more now as they are always the lowest or close and I was to keep with the same company as I'm getting older and want to see if I can encourage longer coverage with loyalty.

Presuming I can get it done, you are more than welcome to see it. My IA is checking for clearances in the next couple of days and then I will attempt to get the DER to do the paperwork. I'll let you know how it goes.

It has been installed on Lycomings as well and I'm currently speaking with B&C about installing it on my IO-360-A3B6D. It will require approval but I think I found a DER to enable that.

I could only find my airplane pictures back to 2001 and I didn't find it in that group. I found lots of other great airplane pictures I haven't seen for awhile though including some great Mooney folks from the past.

i remember that, I don't think I have it but will dig through my old photos to check.

I’m pretty sure the J list is about 24 hours.

They were good at $175K but when I asked for $185K they wanted justification. I'm not sure if they are seeing people over insure or what but it was the first time in 30 years of ownership I had to do that.

Jeff, You should send Jimmy an email, I only requested the M20J guide so I can't send it to you. Adam

I have a 1980 M20J which is equipped at least as well as that one with great paint and interior and I had to provide all the details and the estimated value from Jimmy's valuation guide to get them to go for $185K.

Scott, I have all the senders that were replaced when I put in the Cies senders, they all worked at the time. Let me know if you want to try to arrange something.

I'm not sure I'd include that in the luddite category. As an engineer who spends a lot of time thinking about failure modes, having redundant capabilities not based on the same modality is often critical in systems and I think is critical in this one. Wile I consider myself an early adopter and like living on the cutting edge of technology I wouldn't fly an airplane in any extensive IFR without backups and an important backup is to a GPS outage. I also think about land based outages but since that is a distributed system, not as easy to impact widely. I currently fly with many GPS receivers and two VOR/ILS receivers.

In my 1980 M20J, the annunciator did not have positions for flaps, pitot heat, boost pump, emergency bus, or speed brakes, just gear, low fuel, and high/low voltage. (used to also have vacuum before that was removed, ram air before that was removed, and area nav which only seemed to work with the KNS 80). I have a gear annunciator, the low fuel and high/low voltage are covered on the EIS.

They did have an annunciator panel but you just need the function, not the panel and if your gear lights were all that was left then you are good. I removed my annunciator panel when I added the Gi 275 EIS as that took everything but gear lights and I used an Eaton style annunciator just for the gear.

Best bet for an instructor in the area is @donkaye, MCFI who flies out of SJC.

I'm not sure why but I wait for oil temp to get to 100F for the runup and 130F for takeoff, that usually doesn't take anymore than my normal taxi.

It depends on the use of the GI 275, is it an ADI, HSI, MFD, etc.?

I also used Artcraft and have nothing but good reports. Mine was done 16 years ago and still looks great. I have a few chips that they have touched up over the years and have always had great service. Highly recommended.