CDO

Do I need any paper work to have it installed on mine?

@Browncbr1 thank you, will take a look at the pins again

Please take a look at the picture, does the RED X mean my G5 not getting the GPS data from my GTX 335? Thank You!

Congrats, she is beautiful on the inside too, remind me of g1000 from UND

I would never go back to Lancaster Avionics and I’m from Lancaster. They did a sloppy job on fixing my intermittent transponder when I just got the Mooney. And quoted me about 7500 for an attitude G5. I texted my IA right after I got the quote and bill from fixing the transponder, he told me to just get out of there ASAP.

Getting my popcorn ready, can’t wait, be safe, good luck!

Got mine installed, now waiting for the shop to check it.

@Skates97 does @Aerodon have a phone number to contact him? thank you

If I recall the g5 manual correctly it could be done by GPS atennal go to Gtx 335 first and use the output from 335 back to the g5 via rs232 but I’m not 100% positive on this

@carusoam My plane normally hangared at S37 Smoketown Lancaster, Pa. it is currently getting annual done at 76N Skyhaven. it is a pain to fly without properly working transponder. And would like to do a couple long trips right after I get back in the country

@carusoam I currently have WAAS from Garmin g5 AI, I wouldn’t mind pre owned but it has to be reasonably easy for the installation and get it done soon. I will be out of the country for about month from January if I can not get it done before that then I will wait for the shop to do the 375

I currently have the waas antenna for a G5 and if I understand correctly I can use it for gtx 335 and use the output back to the G5 via Rs232 ?

Sorry I didn’t make it clear, I originally wanted the gnx 375 but all the shops that I talked to don’t have any open slot for 2-3 months. My current transponder not working at all. So I’m leaning toward getting the gtx 335 and have my IA supervises the installation. How long did it take Aerodon to do your harness? I called AS and it takes about 6-8 weeks, this long I would rather wait for the shop to do the 375.

@Skates97 I’m thinking going the same route, my current transponder collin tdr 950 quit. I want to get the Gnx 375 but can’t get any shop to do it for an other 2-3 months. Did you get the custom wire harness with it? Was it hard to do the harness? Any special tools should I get? Thank you,