FredG

Yes, I do reduce power. Throttle back.

I’ll go run some test end of week and will report back more precise observations. will keep you posted. thanks for quick responses.

in cruise, it is at 65-68.

Hi all, I recently got a GI275 EIS installed. I noticed that my oil pressure moves into the Yellow range (just below 60) during some stages of flights (descent), and wondered if that was normal. It is noticeable as the GI275 fires warnings as soon as it moves below 60 and I can't say that I noticed that before with the (quiet) steam gauges. Thank you all. F.

Is there an stc for these? Where can they be sourced? thx

What is going to be the added weight of the bladder installation?

Hi all, I stumbled on this old thread and thought I'd supplement with a video of me taking off from a 650m (2100feet) runway at MTOW, 3 POB. the 50feet clearance is pretty good too. YouTube video

engine mount issue, wouldn't that be replicable on the ground during power up checks relatively easily?

Thank you for your reply. Was that also in the approach / landing phases with issu when you added power back?

I would say it starts at 1800rpm. within the yellow arc but doesn't stop going above.

Hello to you all, I have been having issues with my M20J the past few weeks whilst coming in to land. Following eventless flights, after setting the plane for landing on reduced power, I have a vibration appearing when adding power. It happened twice on the circuit pattern, and once on the runway after landing, adding power to taxi back. I don't have a modern engine monitor, just the basic stuff and all seemed in the green. I have not been able to replicate the issue on the ground from starting up the engine. It seems to happen after a flight out and back, engine hot somehow. I recently got a G5+GFC500 setup installed during the annual. The issue appeared after that and not sure if there is a coincidence. Prior to take off, all engine check are fine. Any pointers? Thanks for your help. F.

The one I got is not, but an electric version exist. Mind you, it is twice the price

I just got my range extending new device and I confirm it fits through the baggage door un changed!

here you are: https://www.deltahawk.com/

Hi folks, Just to let you know that I have successfully located the regulator and adjusted the vacuum down. It's a contortionist exercise to reach and it's with finger tips! I suspect that in a proper adjustment, many of the wiring could be disconnected to give a better access, and most definitely required during the filter change. Thanks for your help. F.