spaz

Is v 0.5 smooth or serrated? engraving them may be a challenge if serrated.

Mike

FYI.  I bought two of the shapeways 3D printed part, but it was not a good fit for the radio master.  It would not actually actuate the switch off, only on because it didn't seat well on the switch actuator.

Mike

Steve,

That was exactly the problem.  I have my pickup in the vent plug on top of the magneto, which looks to be centered.  If I had read page 45 of the JPI manual I might have seen the note for dual mags which I found looking for the programming settings.

Thanks for the quick help.

Mike

Hi Everyone,

 I am having a problem with my JPI that I cannot find an answer too here or elsewhere.  The RPM measured by the JPI, EDM-800, is reading double the Tach RPM.  I have checked the connections on the sensor (Bendix Dual Magneto Magnetic Pickup) as well as the cleanliness of the sensor pickup and all was good.    This problem was intermittent, was gone for a few months and now has returned and I repeated my connection check without luck. 

Does anyone have experience with the JPI doubling the RPM sensed? If so what had you done to resolve it?

Thanks for looking.

Mike

Unfortunately I had to change plans.

I will try to attend as well... Sent from my Xoom using Tapatalk HD

Prefer ILS if available, mostly out of habit and comfort.  My home field does not have an ILS, so LPV is the only option though.

Maybe I am off base but could you convert to an experimental ticket to investigate the newer avionics on a previously certificated aircraft?

Mike