mooney2201

In my expert opinion...once you get a summons to appear in court...it can only go two ways for the shop...PAY dearly for shoddy work...OR MAKE IT RIGHT...AND ITS CHEAPER FOR THE SHOP TO MAKE REPAIRS RIGHT...LOOK WHAT HE DID TO YOUR AIRCRAFT...IF HE HAS INSURANCE THEY WILL PAY...AND IF NOT MAKE THE REPAIRS RIGHT...HE ONLY HAS TWO CHOICES...HES NOT IN A GOOD POSITION...

I would just take him to court for shoddy work....only takes 1 hr to do the paper work...LET THE JUDGE SORT IT OUT AND GET A JUDGEMENT...BELIEVE ME ONCE HE GETS SERVED HE WILL PERSONALLY MAKE IT RIGHT..ITS MUCH CHEAPER FOR HIM....

You probably still have one or more leaking...I've had my m20j for 29 years .you must completely degrease the engine..start with a pristine clean engine...you will find the leak..just take your time

Your are right about it being bulky between the seats..I had the same problem .. remedy was I got small rubber bungy hold down clips, added clips under the seat and pulled excess under the seat...they do make a great cover..extremely comfortable to me

I have found that oil return lines cause this problem, Followed by valve cover gaskets

What does this capacitor do

I have leather yokes on my m20j. Can anyone recommend what to put on the leather to keep it looking great.

I HAVE A VERY LIGHT ALTERNATOR WHINE IN MY M20J....Any suggestions on how to get rid of it...I have a lonestar capacitor on the alternator just doesn't seem to work. Its coming in on my headsets.

Has anyone removed their annunciator...I have a jpi 930 which is stc,d to remove old guages...I want to replace gear down annunciator...with green l.e.d. light....and gear unsafe with red l.e.d. Can this be done legally

I believe there are two of these bearing housings...trim wheel and in the back near jackscrew

Has anyone ever serviced the main bearings in the trim wheel housing. I don't want to remove the side housing and have everything spring out at me..I don't think they have ever been greased before...does the grease get hard.

Ok thankyou ☺

You must save everything to configure module...or you will loose all settings, and I don't need that aggravation to redo all the settings

Golf coast avionics.. Said it would be $35 for the battery. And a 150 labor