Jump to content

WD40 on knobs in cockpit?


Recommended Posts

Hi all! You have all been an amazing source of insight these past few weeks.

Several knobs in my ‘64 M20E are sticky:

+ Ram air flap

+ Standby vacuum

+ Altimeter setting knob

is it acceptable to spray WD40 on their shafts? Any other lubrication suggestions?

Link to comment
Share on other sites

Almost nobody uses what is specified in the maintenance manual. Tri-Flo and LPS-1 seem to be the favorites. 
 

I would say any lube is better than no lube. The control cables usually get sticky along their entire length, not the shafts. You need to apply lube along their entire length the lube should be applied to the spiral conduits. The lube will work it’s way through the spirals to the wire, where the stickiness is.

Don't lube The throttle, prop and mixture cables. They have a plastic sleeve in them and lube will ruin the plastic. You can put a little lube on the knob shafts in the cockpit.

Link to comment
Share on other sites

Uses for WD40 are pretty limited…

I used it as a cleaner…  there are better products for that too…

It definitely isn’t a lubricant…. There are much better products that are tried and tested for that…

There is a rumor by one MSer to be used as an anti-ice coating…. Avoid this as Plan A for anything…

 

Mooney does supply a lubricant list and where it gets used… probably the (maintenance Manual)… find a copy around here somewhere…

PP thoughts only, not a lubrication specialist…

Best regards,

-a-

  • Like 1
Link to comment
Share on other sites

WD40 is a pretty good solvent. If the cable/wire controls are really gummed up, IMHO WD40 can help to break that gum up. But you’ll still need to lubricate the cable/wire afterwards with a lubricant, such as Triflow, as recommended above.

WD40 is also excellent for cleaning  gummed up oil on the belly, inside and out.

  • Like 2
Link to comment
Share on other sites

16 hours ago, jacenbourne said:

+1 for LPS1, use a rag, spray on the cable with the rag underneath and run the rag up and down the length of the cable, then pull and push the cable back and forth a few times to disperse the lube. 

How about cable dressing? It leaves that distinct aroma for a while, too . . . .

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.