TheAv8r Posted October 25, 2019 Report Share Posted October 25, 2019 We need to run a splice off of our existing oil temperature sensor probe to extend it a bit, it's a little tight after we installed the oil filter adapter. This is for a 1965 Mooney M20E on a Lycoming IO-360-A1A. We're having a hard time identifying what gauge wire we should use, is it 16 shielded? Picture: Quote Link to comment Share on other sites More sharing options...
7.Mooney.Driver.0 Posted October 25, 2019 Report Share Posted October 25, 2019 It hard to tell from the picture but more than likely it 18AWG.. Make sure to use good splices other wise it could add resistance and give you an erroneous reading. Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.