Jump to content

jpjp

Basic Member
  • Posts

    49
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

jpjp's Achievements

Explorer

Explorer (4/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

8

Reputation

  1. I am in need of the IPC for a 1985 M20J. Specifically Chapter 25 Equipment/Furnishings. Does anyone have that available? Thanks in advance.
  2. I have a used set for the front seats (2 belts)in grey with brand new shoulder harnesses. I also have a used full set in black for all four seats including the shoulder harnesses. I will take $125 for the two grey belts and $200 for the black set.
  3. I have a set of the plastic pieces with the Mooney logo inserts (2 each). $50 including shipping and they are yours.
  4. That is the windlace. Aero Comfort in San Antonio sells leather replacement kits for both doors.
  5. The only approved repair center would be Pacific Scientific. I sent them four of these units off of a Piper last year and was floored by the pricing and lead time. Unless something has changed be prepared.
  6. The service bulletin is due to failure of the shaft in the inertia reel. The replacements or repaired units will have a shaft that is made of a different material.
  7. Unfortunately it does look like its a Mooney. http://krqe.com/2014/11/12/plane-crashes-near-clines-corners/
  8. Installed in the plane on the L/H rear sidewall. There are three outlets on the panel. One of the flip covers is gone.
  9. I am needing to replace a missing O2 Nut and flip style cover on a K Model. Has anyone had any luck locating replacements or any idea where I can find a replacement? Thanks
  10. Contact Aero Comfort in San Antonio. 210-340-0177
  11. It is most likely the pressed pin that has come loose and is out of the hole. Be careful when removing the armrest as the pin may be rolling around in the mechanism and you can re-use it. The other issue that I have seen is the stop assembly that bolts/rivets onto the backrest is loose. I replaced mine with a Mooney part 140299-011.
  12. Congratulations Tim. It is a great looking interior. Good call on the sheepskin inserts.
  13. I believe that the design has been changed recently. I buddy of mine bought one from Aero Comfort a couple of months back. I saw it installed-it was made of a black fabric that seems to have some stretch and looked like it worked to me. Try Hector again.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.