Jump to content

trmii

Basic Member
  • Posts

    4
  • Joined

  • Last visited

Everything posted by trmii

  1. thomas1142, Congratulations on the project launch. My M20R panel project is underway too. Do you have anything on the Interconnect that you can share. I am still sorting through my redundancy modes. Tom
  2. Here is what I gleaned so far. Meet with shop for details next. Any errors or major omissions? Sent from my iPad using Tapatalk
  3. Very useful photos. Thank you. I can’t find much detail about the GDU 1060 interconnect for this config. What else is needed besides CAN bus and HSDB (Ethernet) to GTN? I will have a GTX345R also connected to the GTN. Made hardware deposit today and want to be ready for the detailed design meeting. Sent from my iPad using Tapatalk
  4. Your panel looks great! What were your considerations in lining the PDF up with the yoke in the 40PFD/60MFD vs "Full Mode". I am in the design phase of a G500/EIS, GFC500, G5, GTN750 upgrade to my 2000 M20R. For the G500, I will have an EIS strip on one side or the other. My current design has the 20% EIS on the left, 40% PFD centered over the yoke and 40% MFD on the right. Any advice would be appreciated. I am also considering placing the GMC 507 at the top of the panel. This lowers the horizon on the PFD about 1" vs where the steam gauge is now.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.