JetSet1967

What is the name of the Eldarado Product?

I had to overhaul my Carb air box. I had to remove the lower cowling, so I decided that I had all this removed and it was crazy not to do the Generator/Alt conversion. I also opted to replace the starter with the lightweight high torque starter as well. The hardest part of the whole install was trimming the baffling so the Alternator would fit. If you are good with your hands it is very easy.

What Interior Parts do you have?

Can someone point me in the right direction. I would like to purchase a CNC router/engraver to make new instrument panels for my M20C mooney.

How much?

Can someone give me your photos and or ideas for mounting the Garmin 796 in the M20C-F

How much for the complete interior including all the plastic panels and side walls?

Did u install it? How do u like it vs the JPI?

I am in need of a replacement Glareshield for my M20C. Can someone point me in the right direction?

Just wondering if anyone has installed one of these. I installed a FP-5 and a UBG-16 in my M20C. I would like to install something more user friendly. I have seen discussion of the JPI 930, but nothing on the EI brand.

I would like to install a external antenna just to clean up the cockpit.

Does garmin make a antenna that you can mount on the exterior of the aircraft that will run both the gps and the xm weather?

so just for clarification....the old field wire can be removed? And if i follow the wiring diagram the amp meter will still work?

Im installing a plane power alternator on my M20C. Replacing my generator. My question is on the voltage regulator there is a field wire, gen wire and a bat wire. Behind the voltage regulator in the Avionics bay is a shunt with the with two large wires and two small wires (the small wires have fuse links. On the generator there were two wires one large and the field wire. The large wire went to the voltage regulator and the field wire went from the gen back to the fire wall (not sure where it went from there. I have run all new wires to the alternator and the voltage regulator that was supplied with the plane power kit and installed it per the install instructions. I would like to use my amp meter in the cluster gauge what do i have to do for that to happen.

Looking for a good avionics shop in East Tx. I am going to install the EDM 930, Aspen or Garmin PFD/MFD and a total redo on my M20C panel.